The MyBedMaker is an innovative solution to help you replace your duvet cover more easily. Place the MyBedMaker supports at the head end under the mattress. Insert the corners of the duvet in the duvet cover and place these corners in the supports. The MyBedMaker will hold the duvet and cover. Then simply pull the cover over the duvet. After use simply slide down the MyBedMaker. The MyBedMaker can remain in place after use.

User instructions MyBedMaker:
1. Place the MyBedMaker supports at the left and right head ends under the mattress only once. The two supports can remain in place. Very practical! 

2. Insert the corners of the duvet in the duvet cover. Secure from below in the opening of the MyBedMaker and then pull tight. By doing this everything stays in place and you don't have to start again.

3. While the MyBedMaker holds the the duvet cover and duvet in place, simply pull the cover over it. If you have a wide duvet cover, fluff up the duvet with cover from below so that the centre of the duvet is also in place. 

4. Release the corners of the duvet and slide the device down.

Watch the video for more information.